| |
|
Stainless Steel Double Enders
| Small |
3.5 inches |
$8.95 |
| Medium |
4 inches |
$9.95 |
| Large |
4.5 inches |
$10.95 |
|
|
|
|
| |
|
Stainless Steel Swivel Bolt Snap
| Small |
3 inches |
$5.99 |
| Medium |
3.5 inches |
$6.99 |
| Large |
4 inches |
$7.99 |
| X-Large |
4.5 inches |
$13.95 |
|
|
|
|
| |
|
Stainless Steel D-Rings
| 2 inch D-ring |
$1.60 |
| 1 inch D-ring |
$1.00 |
| D-ring Holder |
$2.00 |
|
|
|
|
| |
|
Stainless Steel Small Trigger Snap
Stainless Steel
|
|
|
|
| |
|
Rigid D-Rings
These 2-inch rigid D-rings are welded to belt slides and remain in a fixed, raised position. They are helpful when used in a position where the diver cannot see the connection, such as far back on the waist belt. Available as a perpendicular rigid D-ring (used primarily on the waist belt) or 45-degree bend (used primarily on shoulder harnesses). Made of marine grade 316 stainless steel and designed for saltwater use.
|
|
|
|
| |
|
Assembly Screw
The stainless steel assembly screws are used for attaching various accessories to a TransPac harness or to a hard backplate (such as lift bag pouches, suit inflation mounting systems and sidemount buttplates). Another common use is to secure the wing to the TransPac harness or hard backplate when rigged for a single tank--When the BCD is taken off a single tank (perhaps to swap tanks between dives), the cam straps alone are not enough to keep the wing neatly attached to the harness. Designed to fit through a 3/8" hole, the Stainless Steel Assembly Screws include O-rings that create friction to help keep the screw in place.
Sold as a set of two.
|
|
|
|
|
 "Stainless Steel Double Enders")
 "Stainless Steel Swivel Bolt Snap")
 "Stainless Steel D-Rings")
 "Stainless Steel Small Trigger Snap")
 "Rigid D-Rings")
 "Assembly Screw")
